| 1. For removal of these panels at first it is necessary to dismantle the equipment established on these panels (hours, the receiver, etc.). |
| 2. For removal of floor section it is necessary to turn out the handle of the lever of a mechanical check point. |
| 3. The handle of the selector of an automatic check point to remove it is not necessary, – it passes through an aperture in the panel. |
| 4. For panel removal it is necessary to remove заглушки and to turn away the screws which majority is near to an ashtray and a tray. |
| 5. For отворачивания lateral screws of fastening it is recommended to remove forward seats. |
| 6. In back panels and on a part of forward floor panels grooves for seat belts are provided. At panel removal pass belts through these grooves, not assorting belt fastening to a body. |
| 7. At panel removal disconnect all wires, preliminary them having marked. |
| 8. At installation of panels and sections at first it is necessary to establish precisely them in a place, to turn screws on 1–2 turns and to tighten. |
