Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
- 12. A body
   12.1. Maintenance service and repair
   12.2. Vinyl furnish
   12.3. An upholstery and rugs
   12.4. Repair of small scratches
   12.5. Repair of dents
   12.6. Repairing of apertures from a rust or dents
   12.7. Filling and painting
   12.8. Repair of considerable damages
   12.9. Loops and locks
   12.10. A windscreen and motionless glasses
   12.11. Removal and installation of doors
   12.12. Door adjustment
   12.13. Removal and cowl installation
   12.14. Cowl adjustment
   12.15. A cover of a back compartment
   12.16. Bumpers
   12.17. A forward facing lattice
   12.18. External mirrors
   12.19. The forward aerial
   12.20. Removal and installation covered
   12.21. Body support (fastening to the chassis)
   12.22. The hatch
   12.23. The holder of a spare wheel
   + 12.24. The salon equipment
   12.25. Internal panels of doors
   12.26. Facing panels of salon
   12.27. A ceiling upholstery
   12.28. The door-lock switch
   + 12.29. Door glass, стеклоподъемник and the electric motor стеклоподъемника
   12.30. A windscreen
   12.31. Back glass
   12.32. Внутрисалонное a rear-view mirror
   + 12.33. Seats
   12.34. Seat belts
+ 13. An electric equipment
+ 14. Electroschemes




ccf2698e

12.22. The hatch
THE GENERAL DATA

The hatch (1992-98)
1. The switch
2. The electric drive
3. The management block
4. A back arm 		5. The hatch
6. A forward arm
7, 8. Drainage hoses

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove the panel of the switch and disconnect conducting.
3. Remove a ceiling upholstery (subsection 12.27 see).
4. Close the hatch and remove the hatch electric motor (if the hatch to close it is impossible designate position of a cover and directing).
5. Designate position of a reducer of a drive on an arm.
6. Remove the management block.
7. Remove a back arm, get the hatch in gathering and remove a forward arm.
8. Drainage hoses remove only if necessary.
9. For hose removal attach to it a cord, having wound with a tape and stretch a hose in salon (1 – a sealant, 2 – a tape, 3 – a cord, 4, 5 – a hose).
10. Installation is carried out upside-down.
11. A hose stretch, having attached to it a cord a sticky tape (at the left – a forward drainage hose, on the right – back; 1 – a sealant, 2 – a hose).
12. At electric motor replacement slightly open the hatch on 20 sm and establish an aperture of a gear wheel of a reducer so that it was between teeths of a gear wheel of the electric motor (1 – a reducer gear wheel, 2 – a leading gear wheel, 3 – an aperture).
13. At installation of the removed drive combine the put labels.