Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
- 12. A body
   12.1. Maintenance service and repair
   12.2. Vinyl furnish
   12.3. An upholstery and rugs
   12.4. Repair of small scratches
   12.5. Repair of dents
   12.6. Repairing of apertures from a rust or dents
   12.7. Filling and painting
   12.8. Repair of considerable damages
   12.9. Loops and locks
   12.10. A windscreen and motionless glasses
   12.11. Removal and installation of doors
   12.12. Door adjustment
   12.13. Removal and cowl installation
   12.14. Cowl adjustment
   12.15. A cover of a back compartment
   12.16. Bumpers
   12.17. A forward facing lattice
   12.18. External mirrors
   12.19. The forward aerial
   12.20. Removal and installation covered
   12.21. Body support (fastening to the chassis)
   12.22. The hatch
   12.23. The holder of a spare wheel
   + 12.24. The salon equipment
   12.25. Internal panels of doors
   12.26. Facing panels of salon
   12.27. A ceiling upholstery
   12.28. The door-lock switch
   + 12.29. Door glass, стеклоподъемник and the electric motor стеклоподъемника
   12.30. A windscreen
   12.31. Back glass
   12.32. Внутрисалонное a rear-view mirror
   + 12.33. Seats
   12.34. Seat belts
+ 13. An electric equipment
+ 14. Electroschemes


ccf2698e



12.12. Door adjustment

THE GENERAL DATA

The door is regulated in 6 directions.

At correct adjustment the door panel should be заподлицо with adjacent panels of a body.

Position of a door along a body surface is regulated by its moving at the released bolts of fastening of loops to a body.

Выступание doors over a body surface it is regulated at the released bolts of fastening of loops to a door.

Reliability of lock-out of a door is defined by position of a clamp of the lock of a door.

The manufacturer provides also installation of adjusting plates under a clamp.

At correct adjustment the door should not be displaced upwards or downwards at захлопывании.

PERFORMANCE ORDER
1. For clamp adjustment release screws (at the left) fastenings by a shock screw-driver (these screws are tightened hardly (on the right – an adjusting plate)).
2. Then move a clamp and close a door, holding the external handle in unlocking position.
3. Tighten screws at lock-out of a door by a latch (the latch uvula thus comes into a clamp).
4. At correct adjustment of a door the clamp is regulated only in a horizontal direction.