Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. The vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. The switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. The main cylinder of brakes
   11.7. The dosing out valve
   11.8. A regulator of pressure of back brakes (1992-98)
   11.9. The control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Removal of air from a hydrodrive of brakes
   + 11.12. Forward disk brakes
   + 11.13. Back drum-type brakes
   + 11.14. Back disk brakes (1992-98)
   - 11.15. A manual brake
      11.15.1. Adjustment of a cable (1983-91)
      11.15.2. A cable of a manual brake
      11.15.3. The lever of a manual brake
      11.15.4. Колодки a manual brake
   11.16. Antiblocking system (ABS)
   11.17. The hydromodule
   11.18. The overload gauge
   11.19. The gauge of speed
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes




ccf2698e

11.15.2. A cable of a manual brake
THE GENERAL DATA

Cables of a manual brake (1983-91)
1. A drum
2. A bolt 		3. A guard
4. Cables

Cable of a manual brake (1992-98) (on inserts – places of greasing hermetic 3M ATD (at the left) and greasing 8513 SAE J310 NLGI N1)
1. A back brake
2. A disk
3. A regulator spring
4. A cup
5. The probe of a clamping spring колодки
6. A regulator
 7, 8. A spring
9. Распорка
10. Распорка springs колодки
11. Колодка
12. A guard
13. A cable

Removal and installation

PERFORMANCE ORDER
1. Lift the car and remove back wheels.
2. Remove drums (or disks).
3. Turn away a nut натяжителя a cable, disconnect a cable from a lath of the equalizer and remove a guard.
4. Remove колодки back brakes (subsection 11.13.2, subsection 11.14 see) and disconnect a cable, having turned it накидным a key with a cut and having got from the holder on a board.
5. Get a cable from a brake board.
6. Remove скобы and arms of fastening of a cover of a cable to a body and remove a cable.
7. Installation is carried out upside-down.
8. At installation in a brake board turn a cable. Track, that скоба the holder on a board has come into a groove of a cover of a cable, and the cover ledge was turned and has fixed a cable.
9. Rotating an asterisk, establish diameter колодок 253–253,5 mm.