Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. The vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. The switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. The main cylinder of brakes
   11.7. The dosing out valve
   11.8. A regulator of pressure of back brakes (1992-98)
   11.9. The control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Removal of air from a hydrodrive of brakes
   - 11.12. Forward disk brakes
      11.12.1. Колодки disk brakes
      11.12.2. A brake support
      11.12.3. A brake disk
   + 11.13. Back drum-type brakes
   + 11.14. Back disk brakes (1992-98)
   + 11.15. A manual brake
   11.16. Antiblocking system (ABS)
   11.17. The hydromodule
   11.18. The overload gauge
   11.19. The gauge of speed
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes

11.12. Forward disk brakes

11.12.1. Колодки disk brakes

THE GENERAL DATA

The scheme of work of the indicator of deterioration колодок

1. New колодка

2. Worn out

3. A disk

4. The indicator

5. Колодка

On большей parts of cars the deterioration indicator колодок is provided. If at using brakes characteristic squeal check up deterioration колодок is distributed. If the indicator adjoins to a brake disk колодки it is necessary to replace.

The residual thickness колодок can be checked up through a window in a support (1 – a support finger, 2 – a window).

For more detailed survey (uniformity of deterioration on planes and condition checks) колодки should remove. A limiting residual thickness колодок 1 mm (1983-86) and 2 mm (with 1987).

Removal and installation

PERFORMANCE ORDER

1. Lift redock of the car and remove a wheel.
	2. Turn away the bottom finger, cast away a support and fix. Do not suppose removal of protective greasing of a finger of a support, or hit on it of a dirt.
	3. Remove колодки, plates and скобы, remember an arrangement of these details (1 – скоба, 2 – an internal plate, 3 – an external plate).

Installation

Correct orientation of antinoise plates and колодок at assemblage

1. An internal plate

2. Internal колодка

3. External колодка

4. An external plate

PERFORMANCE ORDER

1. Drown the piston in the cylinder of a support by means of a clamp, watching for liquid level in a tank (at installation new колодок the piston should be taken away on considerable distance).

2. Establish plates and скобы in a former order.

3. Establish колодки on a support. If are provided top and bottom скобы it is necessary to replace them together with колодками.

4. Establish a support, a wheel and lower the car.

5. Press a pedal some times that колодки have nestled on a disk. Check up liquid level, if necessary add.

6. Start the engine and again press some times a brake pedal, check up rigidity of a pedal. At the first 15 km of run with new колодками avoid sharp braking.