Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. The vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. The switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. The main cylinder of brakes
   11.7. The dosing out valve
   11.8. A regulator of pressure of back brakes (1992-98)
   11.9. The control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Removal of air from a hydrodrive of brakes
   + 11.12. Forward disk brakes
   + 11.13. Back drum-type brakes
   + 11.14. Back disk brakes (1992-98)
   + 11.15. A manual brake
   11.16. Antiblocking system (ABS)
   11.17. The hydromodule
   11.18. The overload gauge
   11.19. The gauge of speed
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes




ccf2698e

11.8. A regulator of pressure of back brakes (1992-98)

THE GENERAL DATA

The regulator raises stability of the loaded car at sharp braking and is mounted in a back part of a frame. Valve work is defined by a tension of a spring which presses on the lever with certain effort. On the unloaded car established on an equal platform, the length of a spring measured across should be 224–228 mm.

Removal and installation

PERFORMANCE ORDER
1. Disconnect a spring.
2. Designate and disconnect tubes.
3. Turn away bolts and remove a regulator.
4. At installation tighten the union of tubes with the moment 17 Н.м., adjust a spring and pump over brakes.

Adjustment

PERFORMANCE ORDER
For adjustment release a bolt and move an arm.