Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. The vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. The switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. The main cylinder of brakes
   11.7. The dosing out valve
   11.8. A regulator of pressure of back brakes (1992-98)
   11.9. The control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Removal of air from a hydrodrive of brakes
   + 11.12. Forward disk brakes
   + 11.13. Back drum-type brakes
   + 11.14. Back disk brakes (1992-98)
   - 11.15. A manual brake
      11.15.1. Adjustment of a cable (1983-91)
      11.15.2. A cable of a manual brake
      11.15.3. The lever of a manual brake
      11.15.4. Колодки a manual brake
   11.16. Antiblocking system (ABS)
   11.17. The hydromodule
   11.18. The overload gauge
   11.19. The gauge of speed
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes




ccf2698e

11.15. A manual brake

11.15.1. Adjustment of a cable (1983-91)
THE GENERAL DATA

Regulator of a cable of a manual brake (1992-95)

 1. A pin

2. A nut

CARS 1983-91

PERFORMANCE ORDER
1. Check up and if necessary adjust a backlash between колодками and drums.
2. Check up a lever course, – at effort 18,2 кГс the lever should move on 4–5 clicks and completely затормаживать the car.
3. If the number of clicks mismatches norm adjust a cable, having executed the following.
4. Release the lever and working under the car, tighten a cable, rotating a nut of a regulator of a tension of a cable.
5. Start the engine and idling include and release the brake lever, press some times a brake pedal.
6. Repeat this procedure until then yet will not work an automatic regulator (it is defined on click).
7. Check up a course of the lever to full затормаживания, if necessary adjust a tension.
8. Continue procedure while the lever course not begins to correspond to norm.
9. Lift a back part of the car, release the lever of a brake and check up freedom of rotation of wheels.

CARS 1992-98

PERFORMANCE ORDER
1. Check up a lever course, – the lever should move on 4–6 clicks to full затормаживания the car.
2. If the number of clicks mismatches norm adjust a cable, having executed the following.
3. Release a nut and ослабьте a brake cable.
4. Remove заглушку in a board of a brake and dissolve колодки, rotating through an aperture a regulator asterisk (the disk to rotate should not).
5. Turn away an asterisk on 3–4 teeth.
6. Rotating an adjusting nut, adjust a course of the lever of a brake. If the course of the lever is less than norm the reason is the excessive tension of a cable.
7. Be convinced of absence люфта between a nut and a pin of a regulator of a cable.
8. Lift a back part of the car, release the lever of a brake and check up freedom of rotation of wheels.