Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. The vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. The switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. The main cylinder of brakes
   11.7. The dosing out valve
   11.8. A regulator of pressure of back brakes (1992-98)
   11.9. The control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Removal of air from a hydrodrive of brakes
   + 11.12. Forward disk brakes
   + 11.13. Back drum-type brakes
   + 11.14. Back disk brakes (1992-98)
   + 11.15. A manual brake
   11.16. Antiblocking system (ABS)
   11.17. The hydromodule
   11.18. The overload gauge
   11.19. The gauge of speed
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes

11.2. The vacuum amplifier of brakes

THE GENERAL DATA

The vacuum amplifier of brakes (1983-96) for engines G63V and G54В (above) and for a diesel engine


1. An adapter 2. A hose 3. The control valve 4. A pusher 5. The amplifier of brakes	6. A rod plug 7. The remote prorate 8. The vacuum switch 9. A tube 10. The plug

The vacuum amplifier of brakes (1987-98)

1. The union
2. A socket
3. The main cylinder
4. An arm
5. A hose

6. Шплинт
7. An axis
8. The amplifier of brakes
9. An adapter

Tightness check

PERFORMANCE ORDER

1. Start the engine and later 1 mines stop.

2. Press some times a brake pedal, – the pedal course should decrease with each pressing. Otherwise the amplifier негерметичен.

Work check

PERFORMANCE ORDER

1. Press some times a brake pedal.

2. Press slightly a pedal of a brake and start the engine, – the pedal should "leave" to a floor.

Removal and installation

PERFORMANCE ORDER

1. Cautiously disconnect from the amplifier of brakes a vacuum hose 2.

2. Remove the main cylinder.

3. Disconnect a rod of the amplifier from a pedal.

4. Turn away bolts and nuts of fastening of the amplifier to a partition of a motor compartment and remove the amplifier, remove linings and the remote prorate.

5. Installation is carried out upside-down.

6. Tighten all connections according to the demanded moments.