Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. The vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. The switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. The main cylinder of brakes
   11.7. The dosing out valve
   11.8. A regulator of pressure of back brakes (1992-98)
   11.9. The control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Removal of air from a hydrodrive of brakes
   + 11.12. Forward disk brakes
   - 11.13. Back drum-type brakes
      11.13.1. Brake drums
      11.13.2. Replacement колодок
      11.13.3. The wheel cylinder of back brakes
      11.13.4. A board of a back drum-type brake
   + 11.14. Back disk brakes (1992-98)
   + 11.15. A manual brake
   11.16. Antiblocking system (ABS)
   11.17. The hydromodule
   11.18. The overload gauge
   11.19. The gauge of speed
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes

11.13. Back drum-type brakes

11.13.1. Brake drums

THE GENERAL DATA

Drums and колодки (on inserts – places of greasing hermetic ЗМ ATD 8634 (in the centre) and greasing SAE J310 NLGI N1)


1. A drum 2. A spring and a regulator 3. A coupling spring 4. Pins of clamping springs	5. Колодка 6. A tip of a cable of a manual brake 7. Колодка and the lever

Removal and installation

PERFORMANCE ORDER

1. Lift a back part of the car.
2. Remove wheels.
3. Remove a drum, having pulled on itself.
4. If the drum does not give in to removal reduce колодки for what remove заглушку in a brake board, disconnect the regulator lever through an aperture in a board, and rotate a regulator asterisk.
5. On a part of cars the drum can be removed, in regular intervals turning bolts М8х1,25 In special carving apertures.
6. Before drum installation expose an initial backlash between колодками and a drum (subsection 11.13.2 see).

Check

PERFORMANCE ORDER

	1. Check up internal diameter of a drum.
2. Check up ovality, compare to standard data.
3. The manufacturer provides the maximum increase in diameter of a drum after polishing (owing to development and non-uniformity of deterioration) if this diameter after polishing is exceeded a drum replace.
4. Replace a drum at detection of cracks on external and internal surfaces, and also about apertures under nuts.