Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
- 3. Engines
   3.1. Candles
   3.2. Check of wires
   + 3.3. Ignition system
   + 3.4. Engine major repairs
   - 3.5. Diesel and турбодизельный engines of 2,5 and 2,8 l
      3.5.1. Removal and engine installation
      3.5.2. Engine dismantling
      3.5.3. Pistons and rods
      3.5.4. Valves and shaft коромысел
      3.5.5. A head of cylinders and valves, shaft коромысел and коромысла
      3.5.6. A head of cylinders
      3.5.7. Compression check
      3.5.8. A camshaft and газораспределительный the mechanism
      3.5.9. A mechanism drive газораспределения
      3.5.10. Adjustment of backlashes of valves
      3.5.11. Adjustment of a tension of a gear belt
      3.5.12. Removal of the bottom protective casing of a gear belt
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes

3.5.11. Adjustment of a tension of a gear belt

THE GENERAL DATA

The control of a tension of a gear belt on the diesel engine

The belt deflection should make 4–5 mm.

PERFORMANCE ORDER

1. Turn away bolts of fastening of the top protective casing of a gear belt and remove a casing. Turn a cranked shaft before installation of the piston of the first cylinder in position of the top dead point. As the head cover is removed, position of a cranked shaft is necessary for supervising on a belt pulley of a cranked shaft. The notch on a belt pulley of a cranked shaft should settle down opposite to a label of the top dead point on the bottom cover of the case газораспределительного the mechanism. For проворачивания a cranked shaft put on накидной a key the central bolt of a belt pulley of a cranked shaft.

2. Ослабьте on two turns bolts of fastening of the tension device of a belt.

3. Take away with the help накидного a key a cranked shaft clockwise from position of the top dead point on two teeth of a gear pulley of a camshaft. The spring of the tension device starts to operate and establishes a belt in new position.

4. Tighten fastening of the tension device. That thus the tension of a gear belt did not change, at first tighten a bolt in a cut, in then the bottom bolt. Both bolts tighten till the moment of an inhaling 22–30 Н m.

5. For reliability once again check up a tension of a gear belt. For this purpose press a finger a belt, as is shown in drawing. If thus the belt has a deflection of 4-5 mm, it is adjusted correctly and the removed details can be established.