Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Митсубиси Паджеро
+ 1.1. The instrument panel and control means
- 2. Maintenance service
   2.1. Periodicity of service
   2.2. Refuelling capacities
   2.3. Filter replacement
   2.4. The fuel filter
   2.5. A ventilation zolotnik картера (petrol engines)
   2.6. Care of the battery
   2.7. Drive belts
   2.8. Hoses of system of cooling
   2.9. Covers of SHRUS
   2.10. Conditioner service
   2.11. Screen wiper brushes
   2.12. Wheels and tyres
   2.13. Recommended fuel, liquids and lubricants
   + 2.14. The engine
   + 2.15. A cooling liquid
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes

2.7. Drive belts

THE GENERAL DATA

Check and tension adjustment

For check of a condition of a belt turn the engine a starter, looking through a belt on all to length. At detection of any defects or signs of deterioration a belt replace. For check of a tension of a belt press a belt in the middle between pulleys and check up depth of a deflection of a belt. Measure size of a deflection of a belt which should be 6–10 mm at effort 9 кГс.

Adjustment of a tension of a belt of the generator

1. A pulley of the pump of a cooling liquid

2. A generator pulley

3. A pulley коленвала

Bolt of an axis of the generator and bolt of fastening of the unit in an arm cut

At the left – a bolt of an axis of the generator

On the right – a bolt of fastening of the unit in an arm cut

Adjustment of a tension of a belt of the generator

The scheme of adjustment of a tension of a belt roller moving натяжителя

1. An adjusting nut

2. A counternut of an axis of a roller

Adjustment of a tension of a belt by rotation of an adjusting washer

The scheme of adjustment of a tension of a belt of the generator by moving by bolt rotation

Bolt for adjustment of a tension of a belt on the majority of cars

1. Натяжитель

2. A tension

3. A bolt

4. Easing

5. A nut

Places of adjustment of a belt of a drive

1. A generator pulley

2, 5. Натяжитель

3. A generator pulley

4. A pulley коленвала

Adjustment

PERFORMANCE ORDER

1. If it is necessary to adjust a tension of a belt of the generator or the hydraulic booster pump release a bolt of an axis of the unit.

2. Then a bolt of fastening of the unit in an arm cut.

3. Move the unit, having pulled (or having released) a belt and tighten bolts upside-down.

4. On late models the belt tension is regulated by roller moving натяжителя rotation of a nut of a directing hairpin at the released counternut of an axis of a roller.

Removal and installation

PERFORMANCE ORDER

For belt removal execute the same actions, as at adjustment, only take away a pulley (or the unit) so that a belt it was possible to remove and dress the new. It is forbidden to dress a belt, making excessive effort. Be preliminary convinced, that the belt completely corresponds to the removed.

GEAR BELT

Check up integrity of a belt, absence of traces of oil and a liquid. The belt varies through each 96000 km. A removal order look in subsection 3.4.29, subsection 3.4.29.2, subsection 3.4.29.3.