Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
- 10. A suspension bracket and a steering
   10.1. Wheels
   - 10.2. A forward suspension bracket
      10.2.1. Торсион
      10.2.2. The shock-absorber
      10.2.3. The top spherical support of a suspension bracket
      10.2.4. The bottom spherical support
      10.2.5. The stabilizer of cross-section stability
      10.2.6. The top lever of a suspension bracket
      10.2.7. The bottom lever of a suspension bracket and replacement of plugs
      10.2.8. A rotary fist
      10.2.9. The bearing of a forward wheel
      10.2.10. Corners of installation of wheels
   + 10.3. A back suspension bracket
   + 10.4. A steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes




ccf2698e

10.2.8. A rotary fist
THE GENERAL DATA

Order of dismantling of a fist
1. An epiploon
2. A washer
3. The needle bearing 		4. A fist
A.Smazat

Removal and installation

PERFORMANCE ORDER
1. Unblock a nave, having switched the lever of a distributing box in position 2Н and having passed a backing of 2 m.
2. Lift redock of the car and remove a wheel.
3. Remove колодки and a support, take a support aside and fix.
4. Remove a brake disk in gathering with a nave and bearings.
5. Will hang out the bottom lever a jack, выпрессуйте a finger and disconnect from a fist steering draught.
6. Выпрессуйте both spherical support strippers МВ990778-01 and МВ990809-01, nuts of support thus release, but completely do not turn on.
7. Lower the bottom lever a little and remove a fist.

Replacement of the needle bearing and epiploon

PERFORMANCE ORDER
1. Disassemble a fist, having beaten out brass оправкой an epiploon, a washer and the bearing.
2. At assemblage grease and запрессуйте the new bearing заподлицо with a surface of a fist special оправкой.
3. Запрессуйте a new epiploon, fill with greasing an epiploon cavity.
4. Establish a fist upside-down.
5. Nuts of support and a finger of steering draught tighten according to the demanded moments. Support bolts tighten with the moment 80–100 Н.м.