Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
- 10. A suspension bracket and a steering
   10.1. Wheels
   - 10.2. A forward suspension bracket
      10.2.1. Торсион
      10.2.2. The shock-absorber
      10.2.3. The top spherical support of a suspension bracket
      10.2.4. The bottom spherical support
      10.2.5. The stabilizer of cross-section stability
      10.2.6. The top lever of a suspension bracket
      10.2.7. The bottom lever of a suspension bracket and replacement of plugs
      10.2.8. A rotary fist
      10.2.9. The bearing of a forward wheel
      10.2.10. Corners of installation of wheels
   + 10.3. A back suspension bracket
   + 10.4. A steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes

10.2.5. The stabilizer of cross-section stability

THE GENERAL DATA

Details of fastening of the stabilizer of cross-section stability (1992-93)


Removal order 1. Грязеотражатель 2. A rack	3. A collar 4. The plug 5. A stabilizer bar

Details of fastening of the stabilizer of cross-section stability (1994-95)


Removal order 1. Грязеотражатель 2. A rack	3. A collar 4. The plug 5. A stabilizer bar

CARS 1983-91

PERFORMANCE ORDER

1. Lift car redock, remove wheels and грязеотражатель.
2. Turn away a nut of fastening of a rack of the stabilizer to a cross-beam and to the bottom levers. Pay attention to an arrangement of plugs, washers and linings.
3. Remove the stabilizer, check up its condition.
4. At detection of cracks and deformations replace. It is recommended to replace all rubber plugs also.
5. Installation is carried out upside-down.
	6. Tighten a rack nut.
7. Replace the top nut of fastening of a rack of the stabilizer and turn it on 6–8 mm from the carving termination of a rack.
8. Replace nuts of the bottom lever, tighten nuts so that the carving part acted on 6–8 mm (1982-91).
9. On cars 1992-98 tighten a nut that the carving part of a bolt acted on 6–8 mm at length of a bolt of 55 mm, or on 8–9 mm at length of 60 mm.

CARS 1992-98

PERFORMANCE ORDER

1. Lift car redock, remove wheels and грязеотражатель.

2. Turn away a nut of fastening of a rack of the stabilizer to a bar and to the bottom levers. Pay attention to an arrangement of plugs, washers and linings.

3. Remove collars and a bar, remove from a plug bar.

4. Check up presence of cracks and deformations.

5. It is recommended to replace all rubber plugs irrespective of their condition.

6. Installation is carried out upside-down.

7. Tighten bolts and nuts.