Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
- 10. A suspension bracket and a steering
   10.1. Wheels
   - 10.2. A forward suspension bracket
      10.2.1. Торсион
      10.2.2. The shock-absorber
      10.2.3. The top spherical support of a suspension bracket
      10.2.4. The bottom spherical support
      10.2.5. The stabilizer of cross-section stability
      10.2.6. The top lever of a suspension bracket
      10.2.7. The bottom lever of a suspension bracket and replacement of plugs
      10.2.8. A rotary fist
      10.2.9. The bearing of a forward wheel
      10.2.10. Corners of installation of wheels
   + 10.3. A back suspension bracket
   + 10.4. A steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes

ccf2698e Онлайн порнуха. Онлайн порнуха - русоска. Секс онлайн.

10.2.6. The top lever of a suspension bracket

Removal and installation

1. Lift car redock, remove a wheel, the panel of protection of a wing and грязеотражатель.
2. Remove the shock-absorber.
3. Will hang out the bottom lever a jack and unload торсион, having turned away an adjusting nut of a bolt of the lever торсиона.
4. Disconnect a brake hose, release a hose from an arm on the top lever.
5. Remove an arm of the buffer and an arm of a hose of a brake.
6. Расшплинтуйте a nut and выпрессуйте the top spherical support stripper МВ990809-01 or equivalent.
7. Выпрессуйте a finger of steering draught.
8. Turn away a nut and bolts of an axis of the lever, remove adjusting washers and remove the lever.
9. Installation is carried out upside-down taking into account the following.
10. Establish adjusting washers in a former order, tighten nuts of an axis of the lever at first with the moment 54 Н.м., after car lowering – with the moment 100–120 Н.м.
11. A nut of steering draught tighten with the moment 60–90 Н.м., buffer bolts огарничителя – with the moment 9–14 Н.м.
12. Adjust торсион (subsection 10.2.1 see), pump over brakes.