Mitsubishi Pajero

1982-1998 of release

THE GENERAL DATA

Торсион a forward suspension bracket


1. A cover 2. The lever торсиона	3. Торсион

Removal

PERFORMANCE ORDER

1. Lift car redock.

2. Remove a wheel.

3. Will hang out the bottom lever a jack.

4. Remove covers from both terminations торсиона.

5. If removed торсион it will be established again designate its position.

6. Turn away a nut and get торсион from the suspension bracket lever.

Installation

PERFORMANCE ORDER

1. Installation is carried out upside-down taking into account the following.
2. Removed торсион establish on the put labels, new – on a white strip which is combined with a label on the lever (a strip should be turned forward, do not mix right and left торсионы).
	3. At gathering sustain the size A.Dlja of cars of 1983-91 of А=13,5–14,2 sm (left торсион) and 12,4–13,2 sm (right торсион), for cars of 1992-98 of А=14,9 sm (left торсион) and 14,85 sm (right торсион).
4. Adjust a road clearance of a forward suspension bracket (establish the size) for what on removed торсионе turn a nut before its position before dismantling, on new торсионе turn a nut, having established the size In: for cars of 1983-91 of In no more than 6,1 sm (left торсион) and no more than 7,1 sm (right торсион), for cars of 1992-98 of the size In no more than 8,0 sm (both торсиона).
5. Fill covers with greasing.

6. After car lowering check up distance between an arm of the buffer and the terminator (1983-91) (at the left) or between the buffer and the terminator (1992-98) (on the right). These distances should be 71–79 mm and 21–23 mm accordingly.
7. If necessary adjust, rotating a bolt nut торсиона.