Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
- 10. A suspension bracket and a steering
   10.1. Wheels
   - 10.2. A forward suspension bracket
      10.2.1. Торсион
      10.2.2. The shock-absorber
      10.2.3. The top spherical support of a suspension bracket
      10.2.4. The bottom spherical support
      10.2.5. The stabilizer of cross-section stability
      10.2.6. The top lever of a suspension bracket
      10.2.7. The bottom lever of a suspension bracket and replacement of plugs
      10.2.8. A rotary fist
      10.2.9. The bearing of a forward wheel
      10.2.10. Corners of installation of wheels
   + 10.3. A back suspension bracket
   + 10.4. A steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes




ccf2698e

10.2.4. The bottom spherical support

Check on the car

PERFORMANCE ORDER
1. Lift car redock.
2. Disconnect the bottom support (see more low).
3. Screw a support nut.
4. Check up the resistance moment проворачиванию support which should be 1,01–3,39 Н.м.
5. If the moment above specified a support replace if it is less the support can be used but provided that the support rotates without jammings.

Check after removal from the car

PERFORMANCE ORDER
Check up люфт a support clamped in a vice. If люфт exceeds 0,5 mm a support replace.

Removal and installation

PERFORMANCE ORDER
1. Lift redock of the car and remove a wheel.
2. Remove the bottom lever (subsection 10.2.7 see).
3. Turn away bolts and nuts and remove a support.
4. Support installation is carried out upside-down.
5. Tighten bolts and nuts of fastening of a support with the moment 54–74 Н.м. (1983-91) or 81 Н.м. (1992-98). A support nut tighten with the moment 120–180 Н.м.
6. Прошприцуйте a support through a butterdish.
7. Adjust a road clearance (subsection 10.2.1 see) and corners of installation of wheels.