Mitsubishi Pajero

1982-1998 of release

THE GENERAL DATA

Assembly order of the top fastening of the shock-absorber (1992-98)

1. A counternut

2. A nut

Installation of details of fastening of the shock-absorber with remote regulation (1992-98)

1. A drive surface

2. A nut

3. A washer

4. A hairpin

5. An end face of a hairpin of the shock-absorber

The size In = 1,5–2,5 mm

Removal and installation

PERFORMANCE ORDER

1. Lift car redock on height, sufficient for access to the top fastening of the shock-absorber.
2. Remove a wheel.
3. Turn away a nut of the top fastening, remove the rubber buffer and a washer.
4. Turn away a bolt () the bottom fastening and remove the shock-absorber.
5. At assemblage establish the shock-absorber, buffers and turn a nut and a bolt (), not tightening.
	6. Сориентируйте the shock-absorber so that marks of white colour (1) have been turned aside from the car. On cars 1992-98 tighten a nut of a bolt with the moment 88–103 Н.м., on other cars tighten bolts of the bottom fastening with the moment 9–14 Н.м.
	7. On cars 1992-98 tighten a nut of the top fastening so that the size А=1–2 mm.
8. Turn a nut of the top fastening before the carving termination, then turn and tighten a counternut with the moment 12–18 Н.м.