Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
- 9. A running part
   + 9.1. A mechanical transmission
   - 9.2. Coupling
      9.2.1. Coupling adjustment
      9.2.2. A coupling pedal
      9.2.3. Details тросового a drive of deenergizing of coupling
      9.2.4. Coupling with a hydrodrive
      9.2.5. Removal and coupling installation
      9.2.6. The main cylinder of coupling
      9.2.7. The working cylinder of deenergizing of coupling
      9.2.8. Removal of air from a coupling hydrodrive
   + 9.3. Automatic transmission
   + 9.4. The back bridge
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes


9.2.4. Coupling with a hydrodrive


Details of coupling and the mechanism deenergizings (hydrodrive)

1. A transmission
2. A casing of a conducted disk
3. A frictional disk
4. A plug spring
5. Выжимной the bearing
6. The working cylinder
7. A cover
8. A plug
9. The hinge

Highway of a hydrodrive of coupling

1. A bolt накидного the union
2. A lining
3. A hose
4. Скоба
5. A tube
6. The main cylinder
7. The working cylinder


The given procedure concerns both cars with ABS-system, and without ABS-system.

1. Lift the car.
2. Substitute a vessel, turn away a bolt накидного the union on the working cylinder of coupling and merge a liquid from a hydrodrive.
3. Turn away a nut of the union of a tube and remove a hose.
4. If necessary remove an ABS-system connector.
5. Installation is carried out upside-down.
6. Tighten all connections according to the demanded moments.
7. Fill in a liquid and remove air from a hydrodrive.


1. Remove a check point (subsection 9.1.6 see).
2. Remove a returnable spring and выжимной the bearing.
3. Remove the main cylinder with картера a check point.
4. Remove a cover of a plug of deenergizing of coupling.
5. Remove a plug (3) from the hinge (1), having displaced it towards an aperture in картере and having released spring скобу (2). In order to avoid breakages it is forbidden to delete a plug otherwise.
6. If necessary turn out the plug hinge.
7. Installation is carried out upside-down.
8. Grease rubbing surfaces (1) plugs, a rod of the working cylinder and the hinge.