Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
- 9. A running part
   + 9.1. A mechanical transmission
   - 9.2. Coupling
      9.2.1. Coupling adjustment
      9.2.2. A coupling pedal
      9.2.3. Details тросового a drive of deenergizing of coupling
      9.2.4. Coupling with a hydrodrive
      9.2.5. Removal and coupling installation
      9.2.6. The main cylinder of coupling
      9.2.7. The working cylinder of deenergizing of coupling
      9.2.8. Removal of air from a coupling hydrodrive
   + 9.3. Automatic transmission
   + 9.4. The back bridge
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes




ccf2698e

9.2.3. Details тросового a drive of deenergizing of coupling
THE GENERAL DATA

Details of coupling and the deenergizing mechanism (тросовый a drive)
1. A transmission
2. A casing of a conducted disk
3. A frictional disk
4. Spring скоба
5. Выжимной the bearing
6. A spring clamp

7. Consolidation
8, 10. Springs
9. A plug
11. The plug platen
12. A counterbalance
And. To grease

Cable of a drive of coupling

 1. Шплинт

2. A cable

3. The plug

CABLE

PERFORMANCE ORDER
1. From a motor compartment submit a cable and turn away a cover nut, having weakened a cable.
2. Disconnect a cable from a pedal and stretch in a motor compartment.
3. Lift the car.
4. Расшплинтуйте a cable on a check point also extend through an aperture in inflow картера.
5. Get a cable, having extended it through the plug in an arm.
6. Installation is carried out upside-down.

PLUG AND ВЫЖИМНОЙ THE BEARING

PERFORMANCE ORDER
1. Remove a check point.
2. Establish spring clamps so that cuts have been turned to plug eyes.
3. On removed by a check point remove spring clamps and remove выжимной the bearing.
4. Beat out spring clamps of fastening of a plug бородком which diameter in accuracy corresponds to diameter скоб.
5. Remove the platen of a plug, consolidation, both springs and a plug, having remembered an order of installation of these details.
6. If necessary remove a counterbalance.
7. Installation is carried out upside-down.
8. Replace spring clamps of a plug.
8. Grease the plug platen on 25–37 mm from end faces from both parties.
9. Grease выжимной the bearing in the places specified by shading.
10. Grease also rubbing surfaces of eyes of a plug.