Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Митсубиси Паджеро
+ 1.1. The instrument panel and control means
- 2. Maintenance service
   2.1. Periodicity of service
   2.2. Refuelling capacities
   2.3. Filter replacement
   2.4. The fuel filter
   2.5. A ventilation zolotnik картера (petrol engines)
   2.6. Care of the battery
   2.7. Drive belts
   2.8. Hoses of system of cooling
   2.9. Covers of SHRUS
   2.10. Conditioner service
   2.11. Screen wiper brushes
   2.12. Wheels and tyres
   2.13. Recommended fuel, liquids and lubricants
   - 2.14. The engine
      2.14.1. Check of level of oil in the engine
      2.14.2. Replacement of oil and the oil filter
      2.14.3. Check of level of oil in a mechanical check point
      2.14.4. Oil replacement in a mechanical check point
      2.14.5. Liquid level in automatic transmission
      2.14.6. Liquid replacement in automatic transmission
      2.14.7. Oil replacement in a distributing box
      2.14.8. Reducers of the forward and back bridge
      2.14.9. Oil replacement in reducers
   + 2.15. A cooling liquid
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes




ccf2698e

2.14.2. Replacement of oil and the oil filter

THE GENERAL DATA

Timely replacement of oil is most the effectual measures applied by the owner to avoid of premature deterioration of the engine owing to ageing of oil, it разжижения and pollution.

Before the beginning of works prepare the new filter which should correspond to the engine of your car (the filter should be calculated on pressure nearby 17,6 атм (1764 кПа) and oil (the filled volume nearby 6. Oil should be changed on прогретом the engine.

PERFORMANCE ORDER
1. Warm up the engine.
2. Switch off ignition and turn away a stopper of a jellied mouth.
3. Lift the car a jack.
4. Prop up the car a support.
5. Substitute the pallet under a drain stopper.
6. Turn away a stopper.
7. Merge oil in the pallet. After oil running off wipe a stopper pure rags and turn a stopper. Densely tighten a stopper, watching to stripping a thread.
8. Substitute the pallet under the oil filter. By hand or a key turn away the oil filter.
9. Wipe pure rags a place прилегания the filter on the block of cylinders.
10. Slightly oil for the engine a rubber lining of the new filter and turn the filter into place. Tighten the filter by hand while the lining will not adjoin to a surface of the block of cylinders, then tighten on 3/4 turns.
11. Lower the car and fill in oil of the necessary mark, having finished level to the top mark.
12. Start the engine, through 10 сек the lamp of pressure of oil should go out. If the lamp does not die away during 15–30 сек stop the engine, find and eliminate the reason.
13. On the working engine check up tightness of a stopper of the pallet and the filter, having tracked for these places within a minute.
14. Stop the engine and after some minutes again check up oil level. If necessary add.