Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Митсубиси Паджеро
- 1.1. The instrument panel and control means
   1.2. Internal furnish
   + 1.3. Door-locks
   1.4. A bulk mouth of a fuel tank
   1.5. A cowl
   + 1.6. Windows
   + 1.7. The hatch
   - 1.8. Seats and seat belts
      + 1.8.1. Adjustment of a forward seat
      + 1.8.2. A back seat
      1.8.3. Folding of seats
      1.8.4. Раскладывание seats
      1.8.5. Headrests
      + 1.8.6. Seat belts
   + 1.9. A safety air cushion
   + 1.10. Devices and controls
   + 1.11. Start of the engine and a driving
   + 1.12. The ignition lock
   1.13. Anticreeping system
   1.14. The lock of a steering column
   1.15. Engine start in cold weather
   + 1.16. An automatic transmission
   + 1.17. A mechanical transmission
   1.18. A lay brake
   1.19. A brake pedal
   1.20. System of the hydraulic booster of brakes
   1.21. The sound signal warning about deterioration brake колодок
   1.22. System of antiblocking of brakes
   1.23. The lever of adjustment of height of a steering column
   1.24. System of a steering with hydraulic strengthening
   1.25. Rear-view mirrors
   1.26. Heaters of rear-view mirrors
   1.27. Cruise-control system
   1.28. Adjustment of volume and air direction
   1.29. The Heater / the conditioner
   1.30. The conditioner switch
   1.31. Salon heating
   1.32. Heating of a windscreen and glasses of doors
   + 1.33. In case of an emergency
   1.34. Replacement of lamps
   1.35. Capacity of lamps
   + 1.36. Headlights of head light
   1.37. Lamps of illumination of back licence plate
   1.38. A lantern of illumination of a luggage carrier
   1.39. Lamps for reading of cards
   1.40. The top plafond
   1.41. The top lantern of a stoplight
   1.42. A portable lantern
   1.43. Safety locks
   + 1.44. Identification numbers and information tablets
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes




ccf2698e

1.8.5. Headrests

THE GENERAL DATA

Adjustment of headrests

The lever of adjustment of height of a headrest:

At the left – type 1;

On the right – type 2

Soft headrests from above backs of seats can reduce risk of damage of a neck in case of blow behind.

TYPE 1 (SEATS WITH MANUAL ADJUSTMENT)

Headrests can be rejected on two positions forward. If to try to incline them further, they will return to initial position. Headrests cannot be lifted or lowered.

TYPE 2 (SEATS WITH AUTOMATIC ADJUSTMENT)

For reduction of risk of reception of a trauma in case of collision adjust height of headrests so that the centre of a headrest was up to standard of eyes.

To lift a headrest, pull it upwards. To lower a headrest, press on it, having taken away the handle of adjustment of position of a headrest in a direction specified by an arrow. After adjustment of height of a headrest press on a headrest to be convinced, that it is reliably fixed.

Removal of headrests

The adjustment handle:

At the left – type 1;

On the right – type 2

For removal of headrests press on the handle in a direction specified by an arrow, and pull a headrest upwards.

For installation of headrests in the beginning check up, that their forward party looked forward, then establish them on a seat back, having pressed on the adjustment handle, and lower them up to the end downwards that have worked fixing latches. Check up, that position of the adjusting handle was such, as is shown in drawing, and try to lift headrests upwards to check up, whether it is reliable they are fixed.

1. A forward seat

2. A back seat

3. Do not mix!

The prevention

Driving without headrests dangerously. Always operate the car with the established headrests. If headrests are not established, the probability of reception of a trauma in case of failure increases.

Headrests for forward and back seats differ under the form. At installation of headrests do not mix headrests of forward and back seats. Headrests of forward seats above and more thickly.