Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
- 6. The power supply system
   6.1. Introduction
   6.2. Removal of air from the power supply system
   6.3. Removal of water from the fuel filter
   6.4. Replacement of a filtering element of the fuel filter
   6.5. Removal and installation ТНВД
   6.6. Idling adjustment
   6.7. Check of system of prestarting heating of the engine 4D56Т
   6.8. Check of the block of management by prestarting heating
   6.9. Check of the relay of inclusion of starting candles
   6.10. Removal and installation турбокомпрессора
   6.11. Check of pressure of pressurisation
   6.12. The Vozduho-air cooler
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes




ccf2698e

6.6. Idling adjustment
PERFORMANCE ORDER
1. Adjustment of idling of the engine is necessary for carrying out on прогретом the engine, with the adjusted backlashes in the mechanism газораспределения, with correctly established initial corner of an advancing of injection, with a filtering element of the air filter pure and being on a place, at free moving of a cable of management by fuel giving, the adjusting screw of idling on which tip should not press strongly on a control lever giving of fuel ТНВД, at the switched off consumers of a current.
2. Connect a tachometre according to the maintenance instruction and check up frequency of rotation of a cranked shaft of the engine idling which should be within 700–800 rpm.
3. If necessary, rotating the adjusting screw (1) resting against a control lever giving of fuel (3), ослабьте a counternut (2) also establish demanded frequency of rotation of a cranked shaft.
4. After adjustment tighten a counternut of the adjusting screw and disconnect a tachometre.