Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
- 6. The power supply system
   6.1. Introduction
   6.2. Removal of air from the power supply system
   6.3. Removal of water from the fuel filter
   6.4. Replacement of a filtering element of the fuel filter
   6.5. Removal and installation ТНВД
   6.6. Idling adjustment
   6.7. Check of system of prestarting heating of the engine 4D56Т
   6.8. Check of the block of management by prestarting heating
   6.9. Check of the relay of inclusion of starting candles
   6.10. Removal and installation турбокомпрессора
   6.11. Check of pressure of pressurisation
   6.12. The Vozduho-air cooler
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes

6.2. Removal of air from the power supply system

THE GENERAL DATA

Power supply system elements

1. The fuel filter

2. The blowing-off screw

3. Manual топливоподкачивающий the pump

4. The gauge of presence of water in fuel

5. A socket of the gauge of presence of water in fuel

The air filter

And and – installation variants

1. An air pipe connecting the filter with турбокомпрессором

2. The case of the air filter
3. A cover
4. A filtering element
5. An air pipe

Air is necessary for deleting from the power supply system in following cases:

  – Removal of one of топливопроводов;
  – Stops of the engine because of full израсходования fuel;
  – Replacements of a filtering element of the fuel filter.

PERFORMANCE ORDER

1. Turn out the blowing-off screw on the case of the fuel filter.

2. Put rags about the fuel filter to avoid разбрызгивания some fuel.

3. Working as the lever manual топливоподкачивающего the pump, pump over system to an exit of fuel without vials of air from under the blowing-off screw.

4. Turn the blowing-off screw.

5. Again work as the lever manual топливоподкачивающего the pump and completely fill system with fuel to what the increased resistance on the pump lever will testify.

6. At not wrapped up unions топливопроводов a high pressure on atomizers press to the full a pedal of gas and include a starter.

7. As soon as fuel will start to leave streams from under unions топливопроводов a high pressure, tighten the union on atomizers.

8. Warm up and start the engine for the purpose of check of leaks in топливопроводах.