Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
- 13. An electric equipment
13.1. Detection of malfunctions in electric equipment system
13.2. Pressure check
13.3. Short circuit detection
13.4. Check of reliability of grounding
13.5. Check of integrity of a chain
13.6. A finding of not closed chain
13.7. Safety locks
13.8. Burnt through crosspieces
13.9. Automatic switches
13.10. System of safety SRS (a safety pillow)
+ 13.11. A heater
+ 13.12. The conditioner
+ 13.13. Cruise-control
+ 13.14. An audiosystem
+ 13.15. Cleaners of glasses
- 13.16. Devices and switches
13.16.1. A guard of devices / a combination of devices
13.16.2. A speedometer cable
13.16.3. Indexes of pressure of oil, fuel and temperature level, the voltmeter
13.16.4. The printed-circuit board
13.16.5. A multimeter
13.16.6. Switches of screen wipers
13.16.7. The block of switches (a headlight, turn, a glass cleaner)
+ 13.17. Illumination devices
+ 13.18. Accident protection devices of electric chains
+ 14. Electroschemes
|
The speedometer cable connects a reducer on transmission to the index of speed.
Cable replacement is necessary in case of its deterioration when characteristic noise published by a cable can be accepted for malfunction of the engine. Malfunction of a cable can be defined on sharp jumps of an arrow of the index of speed.
On a part of cars the cable is connected to the generator of impulses, instead of with the index of speed. These impulses are used for management of the power supply system and ignition, and also will be transformed to indications of speed and the passed way. Replacement
| PERFORMANCE ORDER |
| 1. For cable replacement it is necessary to disconnect it from a check point. Having turned on накидную a nut to remove a guard of devices and to disconnect from a guard a cover (subsection 13.16 see). |
| 2. The cable gets from a cover. |
| 3. At cable replacement slightly grease it литолом (greasings 25 mm from the end should not be closer). |
|
|
|
