Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
- 13. An electric equipment
   13.1. Detection of malfunctions in electric equipment system
   13.2. Pressure check
   13.3. Short circuit detection
   13.4. Check of reliability of grounding
   13.5. Check of integrity of a chain
   13.6. A finding of not closed chain
   13.7. Safety locks
   13.8. Burnt through crosspieces
   13.9. Automatic switches
   13.10. System of safety SRS (a safety pillow)
   + 13.11. A heater
   + 13.12. The conditioner
   + 13.13. Cruise-control
   + 13.14. An audiosystem
   - 13.15. Cleaners of glasses
      13.15.1. The electric motor and a screen wiper drive
      13.15.2. The electric motor and a drive стеклоомывателя
      13.15.3. A cleaner and a washer of back glass
   + 13.16. Devices and switches
   + 13.17. Illumination devices
   + 13.18. Accident protection devices of electric chains
+ 14. Electroschemes




ccf2698e

13.15.1. The electric motor and a screen wiper drive

Removal and installation

CARS 1983-86

PERFORMANCE ORDER
1. Remove brushes, turn away a nut and push the platen of a drive of the lever under the body panel.
2. Get a cover лючка in the right part of a forward partition.
3. Turn away bolts and get the electric motor, designate position of draught and disconnect draught, having arranged draught and the engine under a right angle.
4. If necessary get draught through лючок.
5. Installation is carried out upside-down.

CARS 1987-91

PERFORMANCE ORDER
1. Remove brushes, turn away a nut and push the platen of a drive of the lever under the body panel.
2. Cautiously hook latches and remove ventilating panels (or one panel).
3. Turn away bolts and get the electric motor, disconnect draught.
4. Disconnect wires and remove the electric motor.
5. If necessary turn away bolts (nuts) of fastening of a plate of the platen and get draught in gathering with the platen through лючок.

The prevention

Position of draught of a drive and the cleaner electric motor is in advance adjusted, therefore remove all drive only as a last resort, having marked a draught relative positioning on the engine.


6. Installation is carried out upside-down.
7. Tighten nuts with the moment 5 Н.м.