Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
- 10. A suspension bracket and a steering
   10.1. Wheels
   + 10.2. A forward suspension bracket
   + 10.3. A back suspension bracket
   - 10.4. A steering
      10.4.1. Removal and wheel installation
      10.4.2. The block of switches on a column
      10.4.3. The ignition lock
      10.4.4. The lock of blocking of a wheel
      10.4.5. A steering column
      10.4.6. Steering draughts
      10.4.7. The pendular lever
      10.4.8. Average steering draught
      10.4.9. Lateral steering draughts
      10.4.10. The steering mechanism
      10.4.11. The hydraulic booster pump
      10.4.12. Removal of air from the wheel hydraulic booster
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes

10.4.5. A steering column

THE GENERAL DATA

Steering column (1983-98)

1. The bottom facing
2. An air line cover
3. The button of a sound signal
4. The module of a pillow of safety
5. A wheel
6. The bottom casing of a column
7. The top casing of a column

8. The lock of blocking of a shaft of a wheel
9. A cover
10. A cable of blocking of a key
(On а/м with АКПП)
11. The cable handle (on а/м with АКПП)
12. A bolt
13. A steering column

PERFORMANCE ORDER

The prevention Before the beginning of works take the measures excluding operation of a pillow of safety.
1. Disconnect the battery from weight.
2. Remove both casings of a steering column, disconnect wires and take aside.
3. Remove the ignition lock (if it is provided by a design).
4. Remove the bottom air line of a heater.
5. Disconnect wires of a column of a wheel.
6. Remove the lock of ignition and wheel blocking, remove the switch of a reminding signal.
7. Disconnect on a column a spring of a pedal of a brake.
8. Turn away a bolt of a collar of a shaft of a wheel, bolts of fastening of a cover to the floor panel, bolts of fastening of an arm of a column and remove a column.
9. At installation enter a column shaft into the steering mechanism, check up correctness of installation of a column and tighten bolts of a column with the moment 22 Н.м.
10. Establish all removed details upside-down.
12. Attach wires.
13. Tighten a bolt of a collar of a shaft of a wheel with the moment 29–34 Н.м.
	14. At column installation this bolt not to turn on and not to release.
	15. Bolts of fastening of a cover turn on hermetic.