Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
- 10. A suspension bracket and a steering
   10.1. Wheels
   + 10.2. A forward suspension bracket
   + 10.3. A back suspension bracket
   - 10.4. A steering
      10.4.1. Removal and wheel installation
      10.4.2. The block of switches on a column
      10.4.3. The ignition lock
      10.4.4. The lock of blocking of a wheel
      10.4.5. A steering column
      10.4.6. Steering draughts
      10.4.7. The pendular lever
      10.4.8. Average steering draught
      10.4.9. Lateral steering draughts
      10.4.10. The steering mechanism
      10.4.11. The hydraulic booster pump
      10.4.12. Removal of air from the wheel hydraulic booster
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes




ccf2698e

10.4.11. The hydraulic booster pump
THE GENERAL DATA

Tank and the pump of the hydraulic booster (1983-89)
Tank
1,2. Hoses
3. A tank
The pump
 1, 2, 4. Hoses
5. A belt
6. The pump
7, 8. Pump arms

The pump of the hydraulic booster (1990-98)
1. A pump cover
2. A belt
3, 4. Hoses
5. A ring
6. A socket of the gauge of pressure (except 12-klapannyh engines of 3,0 l with МКПП)
 7. The pump
8, 9. Pump arms
10. A drain
11. An arm натяжителя
12. A roller натяжителя

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove a tank, disconnect the bottom hose and merge a liquid.
3. If the pulley release pulley bolts acts in film.
4. Release bolts of fastening of the pump and remove a belt.
5. On 24-klapannom the engine of 3,0 l and the engine of 3,5 l a belt remove, having released a bolt натяжителя.
6. Turn the pump by hand and remove the liquid rests.
7. Disconnect from the pump hoses, turn out bolts and remove the pump.
8. Installation is carried out upside-down.
9. At installation of a pressure head hose the groove should be definitely сориентирован.
10. Check up a condition of tubes.
11. Tighten all connections with the certain moments.
12. Fill in a liquid and remove air from the hydraulic booster.