Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
- 10. A suspension bracket and a steering
   10.1. Wheels
   + 10.2. A forward suspension bracket
   + 10.3. A back suspension bracket
   - 10.4. A steering
      10.4.1. Removal and wheel installation
      10.4.2. The block of switches on a column
      10.4.3. The ignition lock
      10.4.4. The lock of blocking of a wheel
      10.4.5. A steering column
      10.4.6. Steering draughts
      10.4.7. The pendular lever
      10.4.8. Average steering draught
      10.4.9. Lateral steering draughts
      10.4.10. The steering mechanism
      10.4.11. The hydraulic booster pump
      10.4.12. Removal of air from the wheel hydraulic booster
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes


ccf2698e



10.4.12. Removal of air from the wheel hydraulic booster

PERFORMANCE ORDER
1. Disconnect a high-voltage wire on the ignition coil.
2. Rotate a wheel in both parties, including a starter on 15–20 seconds
3. Repeat last operation of 5-6 times, watching for liquid level in a hydraulic booster tank. Level at wheel turn to vary should not.
4. Attach a wire and start the engine, idling rotate a wheel in both parties against the stop.
5. Level change at wheel turn should not exceed 5 mm, and the liquid should not be homogeneous (without small vials). If level changes more strongly or if after deenergizing of the engine level sharply increases in the hydraulic booster there is air.
6. Add a liquid and close a tank a stopper.
7. Establish a spare wheel and fix bolts, having tightened them it is insignificant.
8. Lower a wheel. In diagonal sequence tighten bolts of fastening of a wheel the demanded moment.