Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
- 9. A running part
   + 9.1. A mechanical transmission
   + 9.2. Coupling
   + 9.3. Automatic transmission
   - 9.4. The back bridge
      9.4.1. Semiaxes, bearings and epiploons
      9.4.2. Adjustment axial люфта semiaxes
      9.4.3. A reducer of the back bridge
      9.4.4. An epiploon of a reducer of the back bridge
      9.4.5. Removal and installation of the back bridge
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes




ccf2698e

9.4.2. Adjustment axial люфта semiaxes
PERFORMANCE ORDER
1. On the left semiaxis lay a washer in the thickness of 1 mm between the case of the bearing and an end face of a beam of the bridge.
2. Establish right полуось without an adjusting washer and and rings, tighten 4 nuts with the moment 5,6 Н.м.
3. Check up a backlash between the case of the bearing and an end face of a beam of the bridge.
4. Remove полуось and establish the washers which thickness is equal to the measured backlash plus of 0,05-0,20 mm.
5. Establish a ring, having greased with hermetic.
6. Establish полуось and tighten nuts with the moment 54 Н.м.
7. Believe axial люфт and continue assemblage.