Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
- 9. A running part
   - 9.1. A mechanical transmission
      9.1.1. The mechanism of management of a check point
      9.1.2. The gauge of deenergizing of coupling (1990-98)
      9.1.3. The gear change lever (and / m 4х4)
      9.1.4. The switch of a signal of movement by a backing
      9.1.5. An epiploon of a shaft of a check point (or a leading shaft of a distributing box)
      9.1.6. Removal and check point installation
   + 9.2. Coupling
   + 9.3. Automatic transmission
   + 9.4. The back bridge
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes

9.1.3. The gear change lever (а/м 4х4)

THE GENERAL DATA

Details of control levers of a check point and a distributing box


1. The handle 2. A plate 3, 9. A cover 4. The check point lever 5, 7, 10, 12. A lining	6. A framework 8. The lever of a distributing box 11. The case 13. To put hermetic 3M ATD N 8660 from both parties

Check point control lever

1. The lever

2. The top section

3. Inserts

4. An external cover

5. Внутренный a cover

6. Шарнирная a part

PERFORMANCE ORDER

1. Turn out handles of levers of a check point and a distributing box.
2. Turn away screws of fastening of the top plate and remove a plate with a cover.
3. Get the lever in gathering with the case for what translate the lever of a distributing box in position 2Н (4Н for а/м 1992-98) and turn away bolts of fastening of the case шарнирной lever parts.
4. Remove 2 linings and a framework.
5. Get the lever of a distributing box.
6. Remove a cover of the case and a lining.
7. After removal of levers of a check point there should be in neutral position, and a distributing box – in position 2Н (or 4Н for а/м 1992-98).
8. Assemblage is carried out upside-down.
	9. At installation it is necessary to sustain certain position of a nest of the lever.
	10. At assemblage вожно it is correct сориентировать a framework of the lever of a check point (1 – to передку the car).
11. Replace all linings.
12. Tighten all bolts according to the demanded moments.