Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
- 8. Fuel system
   + 8.1. Carburettor engines
   + 8.2. Engines with fuel injection
   - 8.3. Diesel engines
      8.3.1. Топливопроводы
      8.3.2. Atomizers
      8.3.3. The fuel pump (ТНВД)
      8.3.4. Installation of the moment of injection of fuel
      8.3.5. Adjustment of turns of idling
      8.3.6. Adjustment of fast idling
      8.3.7. Spark plugs
      8.3.8. A fuel tank
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes


ccf2698e



8.3.3. The fuel pump (ТНВД)

THE GENERAL DATA

The prevention

After pump installation it is necessary to establish the moment of injection of fuel, for what the special extension piece with the indicator is required to measure выступание control rod ТНВД. In the absence of such equipment to remove the pump and to perform on it any works it is forbidden.


Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight
2. Remove the top cover of a gear belt.
3. Turn away a nut of fastening of asterisk ТНВД.
4. Expose the piston of 1st cylinder in ВМТ a compression step, check up coincidence of all labels.
5. Press asterisk ТНВД by means of a stripper, remove шпонку. After removal of an asterisk rotation коленвала is not supposed.
6. Disconnect from the pump a jack hose.
7. Disconnect from the pump fuel hoses, having wound with their rags, immediately muffle apertures.
8. Disconnect from the pump all wires.
9. Release nuts of unions and remove tubes.
10. Turn away 2 bolts of fastening, get nuts and washers remove the pump and an arm.

The prevention

At pump removal it is forbidden to undertake levers of the accelerating pump or idling.


Installation

PERFORMANCE ORDER
1. Installation is carried out upside-down.
2. Arm bolts tighten with the moment 35 Н.м., bolts (nuts) of the pump – with the moment 26 Н.м., nuts of unions – 29 Н.м.
3. Establish the moment of injection of fuel, remove air then establish a belt cover.