Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
- 8. Fuel system
+ 8.1. Carburettor engines
- 8.2. Engines with fuel injection
8.2.1. Декомпрессия fuel system
8.2.2. The fuel pump
8.2.3. A throttle branch pipe
8.2.4. Adjustment of a cable of an accelerator
8.2.5. Atomizers
8.2.6. A pressure regulator
8.2.7. Редукционный the tank valve
8.2.8. The fuel filter
+ 8.3. Diesel engines
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes
|
Fuel tank and the pump
Removal and installation
| PERFORMANCE ORDER |
| 1. Remove a rug in a back part of a cargo compartment and remove лючок. |
| 2. Execute декомпрессию. |
| 3. Turn away a stopper of a mouth and merge gasoline. |
| 4. Turn on the union and remove from the pump and muffle hoses and tubes. |
| 5. Turn away a nut of fastening and remove the pump. |
| 6. Installation is carried out upside-down. Tighten nuts with the moment 16 Н.м. Before engine start include the pump on 10 seconds |
|
Check
| PERFORMANCE ORDER |
| 1. Without removal the pump is checked by giving of pressure from the battery on a conclusion of a diagnostic socket at the switched off ignition (the socket directly is connected to the pump and is on the right under the forward panel in salon). If the pump works, whether that press a pressure head fuel hose and check up there is a pressure of fuel. |
| 2. The removed pump connect to the battery on 1–2 сек, preliminary plums from it fuel. |
| 3. It is possible to check up also resistance of windings of the pump without its removal, – the ohmmeter should show resistance distinct from zero. |
|
|
|
