Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
- 8. Fuel system
   + 8.1. Carburettor engines
   - 8.2. Engines with fuel injection
      8.2.1. Декомпрессия fuel system
      8.2.2. The fuel pump
      8.2.3. A throttle branch pipe
      8.2.4. Adjustment of a cable of an accelerator
      8.2.5. Atomizers
      8.2.6. A pressure regulator
      8.2.7. Редукционный the tank valve
      8.2.8. The fuel filter
   + 8.3. Diesel engines
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes


ccf2698e


8.2.4. Adjustment of a cable of an accelerator

THE GENERAL DATA

Cable of an accelerator of engines 3,0 (24-klapannogo) and 3,5 l

1. An accelerator cable
2. A cruise-control cable
3. Актюатор
4. The vacuum pump
5. A cable throttle заслонки
6, 7. An adjusting bolt
8. The lever throttle заслонки
9. Draughts (And, In and)

Adjustment

THE ENGINE OF 2,4 L

PERFORMANCE ORDER
1. Adjustment is carried out at the switched off conditioner.
2. Warm up the engine.
3. Check up, that idling turns correspond to norm.
4. Stop the engine.
5. Be convinced of absence of superfluous bends of a cable.
6. Check up a free course of a cable in a cover (1–2 mm for а/м from a mechanical check point and 3–5 mm for а/м from an automatic check point).
7. If necessary adjust a cable course, having executed the following.
8. Include ignition on 15 сек, the engine not to start.
9. Release an adjusting nut completely to weaken the lever throttle заслонки.
10. Rotate a nut prior to the beginning of lever movement, release on 1 turn and tighten a counternut.
11. Be convinced, that the cable terminator concerns a drive of the proof-reader of idling.

12-KLAPANNYJ THE ENGINE OF 3,0 L

PERFORMANCE ORDER
1. Be convinced of absence of superfluous bends of a cable.
2. Be convinced, that draught заслонки concerns the terminator.
3. Release adjusting bolts on an inlet collector and fix a cable cover so that the free course of a cable in a cover was 1–2 mm. If the free course is great, the car will quickly lose speed on liftings, in the absence of a free course of a cable idling turns will increase.
4. Check up completeness of opening and closing throttle заслонки.

24-KLAPANNYJ THE ENGINE OF 3,0 L AND THE ENGINE OF 3,5 L

PERFORMANCE ORDER
1. Be convinced of absence of superfluous bends of a cable.
2. Be convinced, that the lever заслонки concerns the terminator.
3. Be convinced, that a free course of a cable in a cover of 1-2 mm.
4. If necessary adjust, rotating an adjusting nut of a cover, which законтрите a counternut.