Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
- 8. Fuel system
+ 8.1. Carburettor engines
- 8.2. Engines with fuel injection
8.2.1. Декомпрессия fuel system
8.2.2. The fuel pump
8.2.3. A throttle branch pipe
8.2.4. Adjustment of a cable of an accelerator
8.2.5. Atomizers
8.2.6. A pressure regulator
8.2.7. Редукционный the tank valve
8.2.8. The fuel filter
+ 8.3. Diesel engines
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes
|
Lining orientation to a throttle branch pipe (2,4)
|
|
1. A branch pipe
2. To a collector
3. A lining
4. A ledge
|
THE ENGINE OF 2,4 L
Removal
| PERFORMANCE ORDER |
| 1. Execute декомпрессию and disconnect the battery from weight. |
| 2. Merge a liquid. |
| 3. Remove a throttle branch pipe (subsection 8.2.3 see). |
| 4. Disconnect from atomizers sockets. |
| 5. Disconnect from the distributor of fuel gasoline pipe lines. |
| 6. Remove a pressure regulator. |
| 7. Remove the fuel distributor, get atomizers, insulators, уплотнители and rings. Do not suppose hit on dust and dirt atomizers. |
|
Installation
| PERFORMANCE ORDER |
| 1. Replace all linings and уплотнители atomizers and other removed units. |
| 2. Atomizers establish turn to the right-to the left. |
| 3. Tighten bolts and nuts with the moments specified in illustrations. |
|
ENGINES OF 3,0 AND 3,5 L
Removal
| PERFORMANCE ORDER |
| 1. Execute декомпрессию and disconnect the battery from weight. |
| 2. Merge a liquid. |
| 3. Remove an inlet collector. |
| 4. Disconnect from the distributor of fuel gasoline pipe lines. |
| 5. Remove a pressure regulator. |
| 6. Disconnect from atomizers sockets. |
|
7. Turn away bolts of fastening of an inlet pipe (the fuel distributor uniform on 2 heads). |
| 8. Remove the distributor of fuel with форсунами. |
|
9. Get atomizers. On the engine of an atomizer of 3,5 l fasten скобами (1 – скоба; 2 – an atomizer). |
|
Installation
| PERFORMANCE ORDER |
|
1. Replace all insulators and уплотнители atomizers, a lining from other removed units, being guided by an illustration. |
|
2. Tighten bolts and nuts. |
|
Check of atomizers
Atomizers are checked by listening of clicks through a stethoscope or a long screw-driver, measurement of electric resistance of a winding which should be 13–16 Ohm at 20 ° With, and also on a torch at the stand (it is carried out in car-care centre).
The prevention It is forbidden to check atomizers 12 V-pressure from the battery, otherwise they will fail.
|
|
