Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
- 8. Fuel system
- 8.1. Carburettor engines
8.1.1. The mechanical fuel pump
- 8.1.2. The carburettor
8.1.2.1. Removal and carburettor installation
8.1.2.2. Dismantling and carburettor assemblage
+ 8.2. Engines with fuel injection
+ 8.3. Diesel engines
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes
|
The Feedback-carburettor and disconnected details at its dismantle (the engine 2,6)
|
1. The air filter
2. Vacuum hoses
3. A hose of a control system of steams of gasoline
4. A hose of a cooling liquid
5. A fuel hose
6. A cable throttle заслонки
7. A clamp (on а/м with automatic transmission)
|
8. A pin
9. A cable throttle заслонки (on а/м with automatic transmission)
10. Burn down conductings
11. The carburettor
12. A lining |
Adjustment
CABLE OF THE DRIVE THROTTLE ЗАСЛОНКИ
| PERFORMANCE ORDER |
| 1. Warm up the engine. |
| 2. Check up люфт pedals which should be 0–20 mm. |
| 3. If necessary adjust, having moved a cable at the released counternuts of a cover of a cable on the carburettor. |
|
Check
FUEL LEVEL
| PERFORMANCE ORDER |
| 1. Remove a cover of the carburettor and a lining. |
| 2. Turn a cover and check up distance between the top part of a float and a plane of a cover which should be 19–21 mm. |
| 3. If necessary adjust, laying washers under a saddle of the needle valve. |
| 4. For this purpose remove a float, get the valve and turn out a saddle. |
|
ЭЛЕКТРОПНЕВМОКЛАПАН (1987-90)
| PERFORMANCE ORDER |
| 1. Designate and disconnect hoses and a socket from control электропневмоклапана on a partition of a motor compartment. |
| 2. Attach the manual vacuum pump to the union of a hose with a white strip, connect conclusions of the valve to the battery and weight. |
| 3. Create in the valve depression and under the diagramme check up valve work. |
| 4. Check up resistance of the solenoid. Which should be 40–46 Ohm at 20 ° With. |
| 5. If valve work differs from specified in the diagramme, and resistance mismatches norm the valve replace. |
|
|
|
