Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
+ 3. Engines
- 4. Cooling system
   4.1. Introduction
   4.2. The electrofan
   4.3. Replacement of a cooling liquid
   4.4. The water pump
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes


4.3. Replacement of a cooling liquid

Plums of a cooling liquid

1. Establish the handle of adjustment of temperature of heating in extreme right position, having opened thereby краник a heater.
2. Remove a stopper from a jellied mouth of a radiator.
3. Turn out a drain stopper in the left bottom part of a radiator and merge cooling liquid in the capacity substituted under a radiator.
4. Merge cooling liquid from a broad tank. After the cooling liquid will cease to flow from a radiator, turn a drain stopper.

Filling of system of cooling

1. Fill in cooling liquid in a radiator to level of the top edge of a jellied mouth.
2. Remove a stopper from a broad tank and fill in cooling liquid in a tank to label level "Full".
3. Start the engine and warm up it to working temperature (the thermostat should be opened).
4. Finish level of a cooling liquid in a radiator and a broad tank to norm and turn a radiator and tank stopper.