Митсубиси Паджеро
+ 1.1. The instrument panel and control means
+ 2. Maintenance service
- 3. Engines
3.1. Candles
3.2. Check of wires
+ 3.3. Ignition system
- 3.4. Engine major repairs
3.4.1. An engine electric equipment
3.4.2. The ignition distributor
+ 3.4.3. The generator
3.4.4. The battery
3.4.5. A starter
3.4.6. The traction relay of a starter
3.4.7. Gauges
+ 3.4.8. Instructions on service and engine repair
3.4.9. Compression check in cylinders of engines
3.4.10. Specifications of engines
+ 3.4.11. Removal and engine installation
3.4.12. A cover of a head of the block of cylinders
+ 3.4.13. Platens and коромысла
3.4.14. The thermostat of system of cooling
3.4.15. An inlet collector
3.4.16. A final collector
3.4.17. An incorporated collector (a diesel engine with a turbo-supercharging)
3.4.18. Турбокомпрессор
3.4.19. Турбонагнетатель
3.4.20. A radiator
3.4.21. Маслоохладитель
3.4.22. The fan
3.4.23. The pump of a cooling liquid
+ 3.4.24. A head of cylinders
3.4.25. Valves and springs
3.4.26. Saddles
3.4.27. Replacement of directing plugs
3.4.28. Hydropushers
+ 3.4.29. A gear belt and covers
3.4.30. A chain and a cover (the engine 2,6)
3.4.31. The oil pallet
3.4.32. The oil pump and sajlent-platens (виброгасители)
3.4.33. Cam-shafts and support
3.4.34. Check of a condition of a cam-shaft
+ 3.4.35. Pistons and rods
3.4.36. A back epiploon
3.4.37. Radical bearings
3.4.38. A flywheel
+ 3.4.39. An exhaust system
+ 3.5. Diesel and турбодизельный engines of 2,5 and 2,8 l
+ 4. Cooling system
+ 5. Greasing system
+ 6. The power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. A running part
+ 10. A suspension bracket and a steering
+ 11. Brake system
+ 12. A body
+ 13. An electric equipment
+ 14. Electroschemes
|
The worn out saddles vary in car-care centre or the equipped workshop the skilled personnel.
At first the saddle leaves рассверливанием till a thickness of a material of 0,5 mm, and then выпрессовывется. The aperture is developed under a saddle of the repair size. A new saddle запрессовывается in a head нагретую to 250 ° With (drawing of blows is forbidden).
It is necessary to consider, that for each of engine updatings the repair sizes of saddles differ and at their selection be guided by data under the catalogue. After запрессовки a saddle зенкуется under the sizes of a head of the valve. |
|
